In this third week our team finished ramming the first layer of tyres then layed down the second layer to start ramming them. As we were ramming the second layer we found that one of the tyres on the first layer weren't rammed properly as shown at the end of the video below, and so we had to take some of the second layer off to finish ramming the tyre. After that we had to replace the second layer and make sure that is was still level, we did that we the dumpy.
We are now about half way through ramming the second layer of tyres.
This is the short video of our work.
If you're considering a career in building and construction, create a BCITO work profile. We'll do our best to get you an apprenticeship when you're finished school.
